Yamaha F30A Service Manual page 120

POWR
5. Align the notch c in the drive sprocket
with the " " mark d on the cylinder
block.
6. Install the timing belt 8 onto the drive
sprocket, and then install it onto the
driven sprocket so that the part number
e on the belt is in the upright position.
8
CAUTION:
• Do not twist, turn inside out, or bend the
timing belt beyond the maximum limit of
25 mm (1.0 in), otherwise it can be dam-
aged.
• Do not get oil or grease on the timing
belt.
7. Turn the drive sprocket clockwise 2
turns, and then check that the parts are
aligned at the areas f and g as shown.
f
5-25
Power unit
d
c
S67C5063
e
S67C5064
g
S67C5065
8. Install the stator
washer, and flywheel magnet.
NOTE:
See "Replacing the timing belt" (5-3).
Flywheel magnet nut:
157 N·m (15.7 kgf·m, 115.8 ft·lb)
assembly, spring
67C3K11