P/T Function Setting - Q-See QSLO2712 Manual

P/T Function Setting

6、Move cursor up and down to choose the
current number as the No. required,press
【OPEN】 key (open the iris order) to
confirm entering into the former NO. To
move it right and left to choose parameter
needed to change; Use P/T up and
down-ward order to change its parameter,
after that, press 【OPEN】key(open the iris
order) to confirm saving the setting.
7、Turn Page No. up and down to choose other
serial number and repeat step 6 to choose
another No. and change its parameter. (as
shown FIG 8)
8、After programming all the information, press
【CLOSE】 key ( close the iris order ), all
the settings this time will be saved and
then exit the current "Patrol Setting Status "
Attention：
a、Each Patrol can contain 32 presets.
After programming, pres【OPEN】
key (open the iris order) directly, all
the settings won't be saved, that is to
say the users must obey step8 strictly,
or all the settings won't be saved by
the system.
b、In Patrol, the system will stop to
return the present patrol route if
some preset No. is 000.
58
First row second third fourth row
choose
ID Preset Speed Stop
1 000
number
2 000
from
3 000
4 000
top
5 000
to
6 000
7 000
bottom
8 000
change value from left to right
（ FIG5）
Remarks：
It contains 4 lines. The first
line【ID】: number1-32.The
second line 【Preset】 : preset
No.( No1-56 available） ， The
third line【Speed】: preset
speed（50-128rank
selectable） ， The fourth line
【Stop】 : preset parking time
（3－240S selectable）.
ID Preset Speed Stop
1 000
2 000
3 000
4 000
5 000
6 000
7 000
8 000
ID Preset Speed Stop
25
26
27
28
29
30
31
32
120 015
120 015
120 015
120 015
120 015
120 015
120 015
120 015
120 015
120 015
120 015
120 015
120 015
120 015
120 015
120 015
（FIG6）
060 128 010
000 050 030
000 120 240
000 100 015
000 120 015
030 110 015
000 120 015
000 120 015
(FIG8)
English