P/T Function Setting - Q-See QSLO2712 Manual

■ Patrol Setting：

P/T Function Setting

Pattern
Patrol
Scan
Home place
Auto flip
Tilt Max speed 110
Pan Max speed 120
Preset speed
Setup Patrol 1：
●
Remarks：
All the Setup Patrol routes' methods are the same. If you want to rearrange a
new patrol route, you can just repeat the steps as below to get it. Now we take
"Setup Patrol 1" as example.
Operating method as follows:
、
1 Call preset 95 or 64 to enter into the mani menu.
2、 Move the cursor to choose 【
open the iris order) for confirmation, and then enter into P/T
Function Setting Item.
3、 Move the cursor to choose【
【OPEN】key (open iris order) for confirmation, enter into
"Setup Patrol Menu".
4、 Move the cursor to choose【
Patrol
】.Press【OPEN】 key (open the iris order) for
【
confirmation and enter into.
5、Use P/T up and down-ward order to set "On", it stands for
"Open Setup Patrol 1 "Press【OPEN】key (open iris order) for
confirmation and enter into(as shown FIG 5)
Remarks
： When it is set "Off", it stands for"Close Setup
Patrol 1", so the following steps will not be
carried out.
English
On
124
Pan
】 ， press 【 OPEN】 key (namely
Patrol】 in the
【
Setup Patrol 1】
P/T Function Setting
Patrol Setting
Setup Patrol 1 Off
Setup Patrol 2 Off
Setup Patrol 3 Off
Run Patrol 1
Run Patrol 2
Run Patrol 3
Camera
Pan
Info
Alarm
Self act
Lerisure Time
Address
System reset
Pan Press
】.
P/T Function Setting
Pattern
Patrol
Scan
in the
Home place
Auto flip
Tilt Max speed 110
Pan Max speed 120
Preset speed
Setup Patrol 1
Setup Patrol 2
Setup Patrol 3
Run Patrol 1
Run Patrol 2
Run Patrol 3
● Setup Patrol 1
● Setup Patrol 2
● Setup Patrol 3
● Run Patrol 1
● Run Patro 2
● RunPatrol 3
Main Menu
Nothing
005
001
On
124
Patrol Setting
On
Off
Off
57