Setting Up Wifi - Q-See EasyView QN6401X User Manual

4.4 SETTING UP WIFI

When you open up the connection to
your camera, tap on the Setting icon
in the upper right corner to access the
Camera Config window.
This window will allow you to control
how your camera performs. Note that
the audio function is set to Off by de-
fault. Take care to consider where you'll
be placing this camera when deciding
to activate the camera's microphone
or you may share more than you intend.
Click on the Configure WiFi button to
begin setting up the camera to wire-
lessly connect to your network.
Select your preferred network from the
WiFi List. If you own more than one
network, be sure to use the connection
that is stronger in the area where the
camera will be placed.
Secured networks (those with a padlock
icon next to them) will require you to
enter the password. If needed, you can
have the input window show you the
password as you enter it so you can
make sure that you've entered all the
characters.
18
PICTURE 4-15
PICTURE 4-16
PICTURE 4-17
PICTURE 4-18
The camera will then attempt to find
the network's wireless signal. When it
has done so, it will instruct you to un-
plug the Ethernet cable that connects it
to the router.
After the cable is disconnected, the
camera may take several minutes to
reconnect to the router using the WiFi.
It will show an estimated countdown
(in seconds). During this process, the
camera will be offline.
The green network light on the back
will also flash as this takes place.
Once the camera has connected to the router using WiFi, the app will return to
the Camera Config window. You may move the camera to its new location at this
time. The camera will again attempt to reconnect wirelessly once you've plugged
its power cord back in.
Operating instructions are in Chapter 6.
PICTURE 4-19
PICTURE 4-19
19