Table of Contents
Advertisement
Making Input and Output Reference Sync Signal Settings
BKDF-902
7.5%: Set the black setup level to 7.5%.
F3 knob (SD ASPECT) setting
4: 3: Video with aspect ratio of 4: 3
SQ: Squeeze video
Note
If you have connected a black burst signal to the REF IN connector of the
switcher, and SET is set to 7.5%, then a 7.5% setup level is added to the black
burst signals (both SD and HD) output from the REF OUT connector.
Use the following procedure to specify a reference sync signal input to the
switcher, and a reference sync signal generated and output by the switcher.
1
When using the BKDF-901: If the SHIFT button of the DME/SETUP
block is not lit, press it to light it.
When using the BKDF-902: Skip to step 2.
2
Press the SYSTEM button.
A settings sub menu of the System sub menu appears in the display panel.
3
Press the h or H button in the numeric keypad until the Ref (reference
sync signal settings) sub menu appears.
"Ref" appears in the sub menu title display area. If it is already displayed
there, you can skip this step.
BKDF-901
Basic Switcher Settings
73
Advertisement
Table of Contents
