Sony DFS-900M Operating Instructions Manual page 141

Sub menu Operation
Adjust the parameters of
a)
Page Peel
the Page Peel effect.
Adjust the parameters of
a)
Splits
the Splits effect (which
divides the video into
separate segments).
Adjust the parameters of
a)
Mirror
the Mirror effect.
Adjust the parameters of
c)
xxx Defocus
the Defocus effect
(Defocus)
(which blurs the overall
video image).
a) Shown only in GUI menu screens
b) xxx: "M/E DME" appears if you are setting up a transition, and "Keyer"
appears if you are setting up a key.
c) xxx: "Keyer" appears only if you are setting up a key.
To display the WARP sub menus
When using the BKDF-901: Press the SHIFT button in
the DME/SETUP block, turning it off, and then press
the WARP button.
When using the BKDF-902: Press the WARP button in
the DME/SETUP block.
The most recently used sub menu appears in the display
panel.
To switch between sub menus, press the WARP button
repeatedly until the sub menu that you want appears.
Ripple sub menu parameters
Adjust the following parameters to adjust the ripple effect.
Ripple effect example
The Ripple sub menu has four pages. To switch between
pages, press the h and H buttons in the numeric
keypad.
(xxx: "M/E DME" appears if you are setting up a
transition, and "Keyer" appears if you are setting up a key.)
xxx Ripple 1 (1)
Operation target
pattern
Operation
numbers
Select the ripple
224 to 231
type.
232 to 241
242 to 249
252
Select the ripple
frequency.
Select the ripple
amplitude.
Select the ripple
phase.
xxx Ripple 2 (2)
Operation
Select the wave
type.
Adjust the
rotation of the
waves.
Select the
number of apex
points of the star
shape (when
Star is
selected).
Select the
sharpness of
the star shape
(when Star is
selected).
xxx Ripple 3 (3)
Operation
Specify the
number of sides
(when Poly is
selected).
Specify the X
coordinate of
the center point
of the waves.
Specify the Y
coordinate of
the center point
of the waves.
Knob Parameter Settings
F1 Typ (Shape Hor: Horizontal
Type) waves
Ver: Vertical waves
Rot: Rotating
waves
Cir: Circular ripple
Poly: Polygonal
ripple
Star: Star shaped
ripple
F2 Frq (Freq) –100.0 to 100.0
F3 Amp –2.000 to 2.000
F4 Phs (Phase) –8.000 to 8.000
Knob Parameter Settings
F1 Wav (Wave Sine: Sine wave
Type) Square: Square
wave
Triangle: Triangle
wave
Saw: Saw wave
Random: Random
wave
F2 Rot –8.000 to 8.000
(Rotation)
F3 Pnt (Points) 2 to 16
F4 Shp –100.0 to 100.0
(Sharpness)
Knob Parameter Settings
F1 Sid (Sides) 2 to 32
F2 PX (Position –8.000 to 8.000
X)
F3 PY (Position –8.000 to 8.000
Y)
Customizing DME Effects
141