Table of Contents
Advertisement
Message
Display panel
GUI menu screen
Signal Name Failure
Status was modified
Status was because boards
were different modified
Update Failure
Wipe No. reserved
Description
Appears when the display of signal
names is enabled for multi-view
output, and the signal name
display data cannot be sent.
Appears when data is recalled
under the following conditions, if
the sources specified for
parameters cannot be selected
because the configuration of
currently installed option boards
differs from the board configuration
at the time when the data was
saved.
• Reading system data when
starting a control panel
• Executing Recall All Data or
Recall System Data to recall
system data from a USB flash
drive
• Recalling a sequence
• Recalling an event
When this error occurs,
parameters that specify sources
which cannot be selected are set
to BLK.
Appears when an update fails.
Appears when no wipe pattern is
registered for the selected number.
Action to take
Reset the settings of the output
video, and try turning the display of
signal names off and on again
Install option boards in the same
configuration as when the data
was saved, and then execute the
recall again.
Try executing the update again.
Select another pattern.
Messages and Actions to Take
201
Advertisement
Table of Contents
