Connecting The Processor Unit And The Control Panel - Sony DFS-900M Operating Instructions Manual

Connecting the Processor Unit and the Control Panel

Using the control cable supplied with the processor unit, connect the PANEL
connector of the processor unit and the PROCESSOR connector of the control
panel. After connecting the control cable, use two AC power cords (not
supplied) to connect the processor unit and the control panel to an AC power
source. Note that one more AC power cord is required when the BKDF-990 is
installed.
Notes
• Always power off all devices before connecting.
• If you will not be connecting the BKDF-990, connect the AC power cord of
the processor unit to the upper - AC IN connector.
• If you want to attach the supplied rack mounting bracket to the control panel,
refer to the figure on page 215 for the attachment position. Use the screws
supplied with the rack mounting bracket to attach the bracket to the control
panel.
• If you want to attach a rack mounting bracket to the processor unit, use the
optional RMM-10 Rack Mount Kit. Refer to the Installation Manual of the
RMM-10 for information about how to attach the RMM-10.
57
Connecting Up the Switcher