Backing Up, Restoring, And Clearing All Data; Backing Up, Restoring, And Clearing System Data; Backing Up, Restoring, And Clearing File Data - Sony DFS-900M Operating Instructions Manual

3
Press the and
h
until the desired sub menu appears.
Backing Up, Restoring, and Clearing
All Data
In the All Backup sub menu, check the following
parameters and then execute the backup.
Knob Parameter Description
F1 Store Back up all data
F2 Recall Recall all data
F4 Clear Clear all data
To back up all data to a USB flash drive
Connect a USB flash drive, and then press the F1 knob and
hold it down for one second or longer.
Note
If there is not enough free memory on the USB flash drive,
the backup is cancelled and an error message appears.
To recall all data from a USB flash drive
Connect a USB flash that contains the backup data, and
then press the F2 knob and hold it down for one second or
longer.
To clear all data from the memory of the control
panel
Press the F4 knob and hold it down for one second or
longer.
Backing Up, Restoring, and Clearing
System Data
In the System Backup sub menu, set the following
parameters, and then execute the backup.
To back up all data to a USB flash drive
Knob Parameter Description
F1 Store
F2 Recall
F3 No
F4 Clear
To back up system data to a USB flash drive
Connect a USB flash drive, rotate the F3 knob to select a
system data management number (Sys0 to Sys9), and then
168
Backing Up Data
buttons in the numeric keypad
H
Settings
USB
USB
CP
Settings
Backup system USB
data
Recall system USB
data
System data Sys0 to Sys9
management
number
Clear system data USB
press the F1 knob and hold it down for one second or
longer.
Notes
• If there is not enough free memory on the USB flash
drive, the backup is cancelled and an error message
appears.
• The backup file names corresponding to the ten system
management numbers Sys0 to Sys9 are the ten file
names "a" to "j".
• An asterisk (*) appears beside a system management
number when backup data under that number already
exists on the USB flash drive. If you select a number
with an asterisk, the existing data is overwritten when
you press the F1 knob and hold it down for one second
or longer.
To recall system data from a USB flash drive
Connect a USB flash that contains backup system data,
rotate the F3 knob to select a system data management
number (Sys0 to Sys9), and then press the F2 knob and
hold it down for one second or longer.
To clear system data from a USB flash drive
Connect a USB flash that contains backup system data,
rotate the F3 knob to select a system data management
number (Sys0 to Sys9), and then press the F4 knob and
hold it down for one second or longer.
Backing Up, Restoring, and Clearing
File Data
In the File Backup sub menu, set the following parameters,
and then execute the backup.
Knob Parameter Description
F1 Store Backup file data
F2 Recall Recall file data
F3 Type File data type
F4 Clear Location where
data to be cleared
is stored
To back up file data to a USB flash drive
Connect a USB flash drive and then proceed as follows.
1
Rotate the F3 knob to select the type of file data.
Stl: Data saved as still image files
Seq: Data saved as sequence files
Usr: User pattern data
2
Press the F1 knob and hold it down for one second or
longer.
Settings
USB
USB
Stl, Seq, Usr
USB, CP