Sony DFS-900M Operating Instructions Manual page 138

Sub menu
a)
xxx Bevel Color
(Bevel Color)
a)
xxx Border HL
(Hilight Setup)
a) xxx: "M/E DME" appears if you are setting up a transition, and "Keyer"
appears if you are setting up a key.
b) Transition sub menu
c) Key sub menu
To display Border sub menus
When using the BKDF-901: Press the SHIFT button in
the DME/SETUP block, lighting it, and then press the
BORDER button.
When using the BKDF-902: Press the BORDER button
in the DME/SETUP block.
The most recently used sub menu appears in the display
panel.
To switch between sub menus, press the h and H
buttons in the numeric keypad.
Border Color sub menu parameters
Adjust the following parameters to select whether to add a
border, and to adjust the color of the border, if added.
Operation Knob
Select whether F1
to add a
border to an
image.
Adjust the F2
luminance of
the border.
Adjust the F3
saturation
(color density)
of the border.
Adjust the hue F4
of the border.
138
Customizing DME Effects
Operation
Select whether to add
three-dimensional beveled
edges to an image, and adjust
the color of the beveled edges, if
added.
Specify the direction and
brightness of the light source
that illuminates beveled edges.
Border
Border example
Parameter Settings
Bod (Border On: Add
Enable) Off: Do not add
Lum 0.0 to 108.6
(Luminance)
Sat (Saturation) 0.0 to 100
Hue 0.0 to 359.5
Inner Width sub menu parameters
Adjust the following parameters to adjust the widths of the
inner sides of the border.
Note
When you add beveled edges to an image, it is not possible
to adjust the widths of the left, right, top, and bottom edges
independently. Set any one of the parameter values.
For information about beveled edge settings, see "Bevel
Color sub menu parameters" (page 139).
Operation Knob Parameter
Adjust the width F1 L (Left Side)
of the left inner
side border.
Adjust the width F2 R (Right Side)
of the right inner
side border.
Adjust the width F3 T (Top Side)
of the top inner
side border.
Adjust the width F4 B (Bottom
of the bottom Side)
inner side
border.
Outer Width sub menu parameters
Adjust the following parameters to adjust the widths of the
outer sides of the border.
Note
When you add beveled edges to an image, it is not possible
to adjust the widths of the left, right, top, and bottom edges
independently. Set any one of the parameter values.
For information about beveled edge settings, see "Bevel
Color sub menu parameters" (page 139).
Operation Knob Parameter
Adjust the width F1 L (Left Side)
of the left outer
side border.
Adjust the width F2 R (Right Side)
of the right outer
side border.
Adjust the width F3 T (Top Side)
of the top outer
side border.
Adjust the width F4 B (Bottom
of the bottom Side)
outer side
border.
Settings
0 to 200
0 to 200
0 to 200
0 to 200
Settings
0 to 100
0 to 100
0 to 100
0 to 100