Adding Lighting Effects - Sony DFS-900M Operating Instructions Manual

Defocus effect example
Operation Knob Parameter
Adjust the F4
amount of
blurring.

Adding Lighting Effects

You can adjust the parameters of the Light sub menu to
add lighting effects to images.
Example of a lighting effect applied to a ripple effect
Use the sub menus of the Light sub menu to do the
following.
Sub menu
a)
xxx DME L.Type
(Type)
b)
Light 1 and 2
a) xxx: "M/E DME" appears if you are setting up a transition, and "Keyer"
appears if you are setting up a key.
b) Shown only in GUI menu screens
To display the Light sub menus
When using the BKDF-901: Press the SHIFT button in
the DME/SETUP block, lighting it, and then press the
LIGHT button.
When using the BKDF-902: Press the LIGHT button in
the DME/SETUP block.
The most recently used sub menu appears in the display
panel.
To switch between sub menus, press the h and H
buttons in the numeric keypad.
146
Customizing DME Effects
Settings
Amt 0 to 100
(Amount)
Operation
Select the type of light source.
Specify the size of the light source,
its position, and the color of
highlighted parts.
To select the type of light source in the
Type sub menu
Operation Knob Parameter
Select the
F1 Typ (Type)
type of light
source.
(Select Off if
you do not
want to add a
lighting effect
to the image.)
Light 1 and Light 2 sub menu parameters
When you have selected 1-HL or 2-HL in the Type sub
menu, use the Light 1 and Light 2 sub menus to adjust the
size and position of the light source and to adjust the color
of highlighted parts.
The Light 1 and Light 2 sub menus each have two pages.
To switch between pages, press the h and H buttons in
the numeric keypad.
(xxx: "M/E DME" appears if you are setting up a
transition, and "Keyer" appears if you are setting up a key.)
xxx L1/xxx L2 Position (Position)
Operation Knob Parameter
Specify the size F1 Siz (Size)
of the light
source (plane
light source)
Specify the X F2 PX (Position
coordinate of X)
the center point
of the light
source.
Specify the Y F3 PY (Position
coordinate of Y)
the center point
of the light
source.
Specify the Z F4 PZ (Position
coordinate of Z)
the center point
of the light
source.
Lxxx L1/xxx L2 Color (Color)
Operation Knob Parameter
Specify the F1 Opac
mixing ratio (Opacity)
between the
color of the
highlighted
parts and the
base color.
Settings
Off: No light
source
1-HL: Highlight 1
2-HL: Highlight 1
HL/LL: Highlight
and low-light
Settings
0.0 to 100.0
–1.000 to 1.000
–1.000 to 1.000
–1.000 to 1.000
Settings
0 to 100.0