2. Installation Instruction
2.1 Wiring Diagram
Power supply connection
Attention:Please check the voltage rating and electric current, it is as below,
Voltage Rating
DC 12V
Connection of control cable
PTZ control: connect RS-485 cable to PTZ control keyboard or DVR. If you control
more than one camera, RS-485 cable needs to be settled parallel position.
Note:①The RS-485 cable can be connected optionally
②Protocol and baud rate of PTZ control keyboard or DVR can be settled
optionally
③Some cameras in CCTV system should set different PTZ dome address
Video
Use BNC plug to connect video signal cable.
Power supply: DC 12V 3A interface
Control cable: RS485 control
Video cable: BNC interface
Range of Voltage Rating
±5%
7/ 24
Electric Current
3A