Advertisement
INSTALLATION
1. Loosen the 4 fix screws on the housing cover by using the attached wrench (Figure 1).
Carefully uncap the housing cover as the direction shown below (Figure 2), please pay attention
not to damage the lens. To remove the housing cover, push the hinges to the bottom of the
bracket, the hinges can be easily removed from the bracket.
2. Remove the camera.
To remove the camera, first unplug the wire connection on the back of the camera.
Then loosen the 2 locking screws on the camera base, push the camera base to the right
(toward heater direction, as shown in Figure 3), remove the camera from the mounting
base. Reinstall the camera and the cable while the base mounting is completed.
Figure 1
Board Lens
Figure 2
Vari-Focal Lens
Figure 3
2
Heater
Locking Screws
Advertisement
