Advertisement
1.4 Dimensions
3. Installation
Screw Hole
1
Optionally thread the
cable through this hole
1. Attach the Camera Bracket to the surface where you want to mount the camera and mark the
Screw Hole locations on the surface. Drill two screw holes on the surface and insert the
supplied two Anchors to the holes. Screw the Camera Bracket to the surface using the supplied
two Screws.
2. Optionally drill another hole in the middle between the two screw holes only if you want to
thread the cables through the surface.
3. Connect the camera to a 12VDC power source using the supplied DC Power Pigtail Cable or
power adapter. Connect the video output cable to the monitor.
4. To adjust the Sunshield or Camera angle, loosen the two screws on both sides and then adjust
the angle.
5. To adjust the Bracket angle, loosen the screw on both sides and then adjust the angle.
75.5mm / 3"
2
Screw Hole
1
68.8mm / 2.7"
4
Loosen to adjust Sunshield / Camera Angle
5
Loosen to adjust Bracket Angle
4
Loosen to adjust Sunshield / Camera Angle
Power Cable
Video Output Cable
3
2
Advertisement
