Roland VS-1680 Owner's Manual page 44

Chapter 2 Basic Operation
Storing Recording Settings (Recording)
Select this when you want to record the performance input via the INPUT jacks.
If you wish to cancel the settings procedure, press [F6 (EXIT)].
1. Press [EZ ROUTING].
The EZ Routing icon appears in the display.
2. Press [F4 (Exec)]. If "Exec" does not appear in [F4], first press [PAGE] until
fig.02-18(ez_con(rec).eps)
3. Press [F1 (Rec)].
4. Specify which source is to be recorded on each track. First press the source
* Sources that have Stereo Link set to "On" cannot be recorded to tracks on which
fig.02-19(rec_step1.eps)
44
"Exec" is displayed, and then press [F4 (Exec)].
input channel SELECT button, then press the track channel STATUS button
for the track to which the source is to be recorded. With the EZ Routing, you
can assign a single source to be recorded on up to two tracks. Additionally,
by pressing the SELECT button when the input is not assigned to any track,
you can have the source assigned to the MIX bus (the signal is not record-
ed). Press [ ] and [
dial to select the V-track to which you want the source recorded.
Stereo Link is set to "Off" with the EZ Routing.
] to move the cursor. Rotate the TIME/VALUE