Roland VS-1680 Owner's Manual page 119

Loading Data From Disks (Extract)
1. Select the load (restore) destination drive (internal
hard disk) as the current drive.
2. Insert a disk that was copied by Archives Store
into the Zip drive.
3. Press [PLAY (DISPLAY)].
4. Hold down [SHIFT] and press [F1 (SONG)].
The Song menu icon appears in the display.
5. Press [F3 (AcExt)]. If "AcExt" does not appear in
[F3], first press [PAGE] until "AcExt" is dis-
played, then press [F3 (AcExt)].
fig.06-11(cp_arc_ext.eps)
6. If several disk drives are connected, press [F1
(SelDr)] to have a list of the drives displayed. Use
[ ], [ ], [ ], and [
drive, and press [F1 (Back)].
fig.06-12(cp_arc_ext_seldr.eps)
7. Use [
] and [ ] to move the cursor to "Source
Song."
] to select the source
Chapter 6 Use with a Zip Drive
8. Songs that are marked are loaded. Use the
TIME/VALUE dial to move the cursor to the song
you want to restore and press [F4 (MARK)]. By
pressing [F3 (ALL)], you can place and remove
Marks from all of the songs. In addition, you can
press [F2 (SelSg)] to display a directory of the
songs. At this point, after you have placed a Mark
at the song you want, press [F1 (Back)].
fig.06-13(cp_arc_ext_selsg.eps)
9. Press [
] to move the cursor to "Erase All
Song."
Erase All Songs
When this is set to "On," the recover procedure is car-
ried out after the destination drive is initialized. If you
want to perform the recover procedure leaving songs
already saved in the current drive as they are, then set
this to "Off."
10. Press [F5 (Exec)].
A message asking if you want to continue appears in
the display.
11. Press [YES].
When "Erase All Songs" set to "Off," "STORE
Current?" (Store the current song?) appears in the dis-
play.
12. If you wish to save the current song, press [YES];
if not, then press [NO]. If you have selected a
demo song, then press [NO].
13. Execute the load. When copying over multiple
disks, "Insert Disk #" (# indicates the number in
the order of insertion) appears in the display.
Insert the next disk and press [YES].
14. When the Archive Extract procedure is finished,
return to Play condition.
119