Moving Performance Data (Track Move) - Roland VS-1680 Owner's Manual

TO (To point)
Specifies the reference time of the copy destination.
11. Press [F4 (Exec)].
This executes Track Copy.
12. When the copy is completed correctly,
"Complete" appears in the display.
13. Press [PLAY (DISPLAY)].
Return to Play condition.

Moving Performance Data (Track Move)

This operation moves the playback data in a
specified range to another location. This is
convenient for correcting timing mistakes that
can occur during recording.
fig.04-08(tr_mv.eps)
Example 1: Moving with in the same track
A
Start End
Example 2: Moving to a different track
B
Start End
* Set the length of the data to be moved so that it is greater
than 0.5 seconds. With data shorter than 0.5 seconds,
even though it can be moved, the sound will not play
back. In addition, make sure that no data remains within
0.5 seconds before or after the designated range. Data
remaining within this 0.5 seconds will not be played back.
1. You can move the tracks that are currently audi-
ble. Select the V-track that contains the move
source playback data, and prepare that data for
playback.
2. Hold down [SHIFT] and press [F2 (TRACK)].
3. Press [F1 (Tr/Ph)] so that Track Edit menu
appears in the display.
Chapter 4 Editing a Recorded Performance (Track Editing)
A
To Time
B
To Time
4. Press [F3 (Move)]. If "Move" does not appear in
[F3], first press [PAGE] until "Move" is displayed,
and then press [F3 (Move)].
5. Press [F1 (SelTr)].
6. Press the SELECT button for the channel contain-
ing the move source track.
The button indicator lights.
Alternatively, press [ ], [
move the cursor to the track you want to move, and
then press [F3 (MARK)] or [YES].
This moves the performance data on the track contain-
ing the mark. When [F2 (ALL)] is pressed, you can
place or remove the marks on all the tracks simultane-
ously.
fig.04-09(tr_mv_sel.eps)
7. Press the STATUS button for the move destination
track.
The button indicator lights red.
Rotating the TIME/VALUE dial allows you to specify
the move destination V-track. For example, "1-1" indi-
cates "Track 1, V-track 1," and "9L-1" indicates "Track
9 (Stereo Track 9/10, left channel), V-track 1."
* Do not designate V-tracks that have already been specified
as move destinations for other Tracks.
8. Repeat Steps 6 and 7 if you want to move multiple
tracks simultaneously.
9. Press [F1 (Back)].
10. Press [
], [ ], [
cursor. Set each of the values.
fig.04-10(tr_mv_prm.eps)
], [ ], and [ ] to
], and [ ] to move the
85