Inserting An Effect Into The Master Block - Roland VS-1680 Owner's Manual

EFX1 (Effect Insert Switch)
This sets how the effects are connected.
Off: There is no Insert.
Ins: Inserts in both channels of the stereo effect.
InsL: Inserts in the left channel of the stereo effect.
InsR: Inserts in the right channel of the stereo effect.
InsS: Inserts in the combined left and right channels
of the stereo effect in series.
fig.05-05(inslrs.eps)
Ins
EQ
(2band, 3band)
InsL
EQ
(2band, 3band)
InsR
EQ
(2band, 3band)
InsS
EQ
(2band, 3band)
* When Ins or InsS is selected, that effect cannot be used on
any other channel. Furthermore, when InsL or InsR is
selected, that effect can be inserted on only one other
channel.
Snd (Insert Send Level)
This adjusts the level of the signal (-42–6 dB) sent to
the Insert effect. Set the initial value to "0 dB."
Rtn (Insert Return Level)
This adjusts the level of the signal (-42–6 dB) returned
from the Insert effect. Set the initial value to "0 dB."
5. At this point, you are ready to insert EFX1 into the
selected channel. Press [PLAY (DISPLAY)].
Return to Play condition.
* You can insert EFX2–EFX4 in the same way.
L L
EFX
R R
L L
EFX
EFX
R R
L L
EFX
R R
Chapter 5 Using the Internal Effects (VS8F-2)
Inserting an Effect into the Master
Block
This inserts the effect into the MASTER Out. After the
mix for each channel is completed, the entire song is
put through the compressor, which is convenient at
such times as when you listen to the total volume
while mixing down.
1. Press [MASTER].
The button indicator lights, and the Master screen
appears in the display.
2. Press [F1 (Ef1In)]. If "Ef1In" does not appear in
[F1], first press [PAGE] until "Ef1In" is displayed,
then press [F1 (Ef1In)]. Alternatively, use [
[ ], [ ], and [
"EFXIns."
3. Press [YES].
4. Use [
], [ ], [
cursor. Rotate the TIME/VALUE dial.
fig.05-06(masterins.eps)
Effect Insert Switch
Insert Return Level
Insert Send Level
EFX1 (Effect Insert Switch)
This sets how the effects are connected.
There is no Insert.
Off:
Ins: Inserts in both channels of the stereo effect.
Snd (Insert Send Level)
This adjusts the level of the signal (-42–6 dB) sent to
the Insert effect. Set the initial value to "0 dB."
Rtn (Insert Return Level)
This adjusts the level of the signal (-42–6 dB) returned
from the Insert effect. Set the initial value to "0 dB."
5. At this point, you are ready to insert EFX1 into the
Master Block. Press [PLAY (DISPLAY)].
Return to Play condition.
* You can insert EFX2–EFX4 in the same way.
],
] to move the cursor to
], and [ ]] to move the
105