Selecting A Multi-Effect (Multi Effects); Editing The Multi-Effect - Roland TD-25 Parameter Manual

Kit Edit

Selecting a Multi-Effect (Multi Effects)

Here you can select an effect that is applied to the drum kit.
Effect Type
Effect Type Explanation
OFF No effect is applied.
STEREO DELAY This is a stereo delay.
This is a reverse delay that adds a reversed sound of the input sound as a delayed sound. A
REVERSE DELAY
chorus is connected immediately after the reverse delay.
TAPE ECHO Simulates a tape-type echo unit of the past.
This is a stereo chorus. A filter is provided so that you can adjust the timbre of the chorus
CHORUS
sound.
This is a stereo phaser. A phase-shifted sound is added to the original sound and
PHASER
modulated.
STEP PHASER
This is a stereo phaser. The phaser effect will be varied in stepwise motion.
This is a stereo flanger. (The LFO has the same phase for left and right.) It produces a
FLANGER
metallic resonance that rises and falls like a jet airplane taking off or landing.
REVERB
Adds reverberation to the direct sound, simulating an acoustic space.
LONG REVERB This is a very rich sounding reverb with a choice of Character.
A saturator which distorts the sound is connected in parallel with a compressor, producing
SATURATOR a rougher tonal character and boosting the loudness. This also cuts the low-frequency
region of the input audio.
SUPER FILTER This is a filter with an extremely sharp slope. The cutoff frequency can be varied cyclically.
This is a low-pass filter equipped with overdrive. It cuts the upper range and adds
FILTER+DRIVE
distortion.
AUTO WAH Cyclically controls a filter to create cyclic change in timbre.
LO-FI COMPRESS This is an effect that intentionally degrades the sound quality for creative purposes.
Intensely distorts the sound. The tone quality of the distorted sound is adjusted with a
DISTORTION
filter.
OVERDRIVE Mildly distorts the sound. The tone quality of the distorted sound is adjusted with a filter.
This is an equalizer which cuts the volume greatly, allowing you to add a special effect to
ISOLATOR
the sound by cutting the volume in varying ranges.
This is an effect that applies amplitude modulation (AM) to the input signal, producing bell-
RING MODULATOR like sounds. You can also change the modulation frequency in response to changes in the
volume of the sound sent into the effect.
This is a ring modulator that uses a 8-step sequence to vary the frequency at which
STEP RINGMOD
modulation is applied.
Shifts the pitch of the original sound. This pitch shift can add two pitch shifted sounds to
PITCH SHIFT
the original sound.
AUTO PAN Cyclically modulates the stereo location of the sound.
* For details on the parameters of each effect, refer to p. 18.

Editing the Multi-Effect

Editing detailed parameters (MFX)
In the Multi Effects screen, press the [KICK] (ENTER) button to access
the MFX screen.
You can edit detailed parameters for the effect type that you select.
* For details on the parameters of each effect, refer to p. 18.
Specifying the routing and levels (MFX ROUTING)
In the MFX screen, press the [KICK] (ENTER) button to access the MFX
ROUTING screen.
For each pad, you can specify the amount of multi-effect that is
applied, and whether the unprocessed sound is mixed.
Parameter Explanation
In addition to the sound that is processed by
DRY+MFX the MFX, the unprocessed (DRY) sound is also
output.
DRY+MFX/
MFX ONLY Only the sound that is processed by the MFX
is output.
MFX ONLY
Lowering the MFX Level lowers the volume.
Send Level Level sent to MFX
MFX Level
Output level of the MFX
4