Options; 810 Ctls Module - VeriFone Vx810 Reference Manual

S
ETUP

Options

Options
x
V

810 CTLS Module

NOTE
NOTE
26
V X 810 R G
EFERENCE
VeriFone ships variants of the V
a different configuration. Additionally, these variants can be ordered with different
options.
This SD card slot on the V
installing an optional V
transactions.
x
The V 810 CTLS module is composed of an RFID canopy with an RFID SD Card
attached via flex cable.
x
Figure 7 V 810 PIN pad with V
x
To install the V 810 CTLS module:
1
Place the device facedown on a soft, clean surface to protect the lens from
scratches.
2
Remove the Dummy SD card from the SD card slot of the V
Store the Dummy SD card in a safe place. This may be used again in the event
you want to remove the V
3
Carefully insert the RFID SD card of the RFID canopy into the SD card slot of
x
the V 810.
Use your fingers to push the RFID SD card into the SD card slot until the card
clicks into place. Take care not to let the SD card slip backwards once fully
inserted. SD card slot mechanisms do not prevent SD cards from being pulled
out even thought the SD card clicks into place.
Figure 8 Sliding the RFID Canopy
UIDE
x
810 for different markets. Your device may have
x
810 also serves as an SDIO expansion port for
x
810 CTLS module used for contactless smart card
x
810 CTLS Module
x
810 CTLS module.
x
810.