Information Messages - VeriFone Vx810 Reference Manual

S M
YSTEM ESSAGES

Information Messages

Information
Messages
DOWNLOAD NEEDED
LOAD DBMON.OUT
LOAD TERMINAL
MANAGEMENT AGENT
RECEIVING NOW
SYS MODE CLEAR
CLEARING FLASH
PLEASE WAIT
144
V X 810 R G
EFERENCE
The following information messages may appear when the V
system mode.
The operating system is unable to start the application specified in the *GO
variable for the following reasons:
•
Application is not resident in the device.
•
The *GO variable is not set in the Group 1 CONFIG.SYS file.
•
The application file specified in the *GO variable does not exist in Group 1.
(The *GO variable cannot specify an application file stored in a file group other
than Group 1.)
•
The application or a shared library used by the application either does not
exist or is not authenticated. All executables must be authenticated to run on
the device.
•
There is not enough memory available to run the application requested in the
*GO variable.
This message displays when the
selected. The DBMON.OUT debugging monitor program is included in the SDK,
but is not stored in the device's memory. To use the debugging tool, you must
sign, download, and authenticate the DBMON.OUT application.
This message displays if you select
(optional) Terminal Management Agent (TMA) software is not resident in the
x
V 810 device. The TMA software is required to perform remote diagnostics. For
more information about support for remote diagnostics, contact your VeriFone
service provider.
In back-to-back downloads, the Target (receiving) device displays this message
on data transfer initiation when pressing the asterisk key (
press on either device (sending or Target).
CANCEL
This message is displayed when you select
and select
CLEAR GROUP_NN F2
ROM memory of a specific file group (Group 1–15) or from the entire flash ROM
memory. This message remains until the files within the file group or all files in
flash ROM are deleted.
If you select
CLEAR ALL FILES F3
system – not the files stored in SRAM – are erased.
UIDE
option in
DEBUGGER F5
in
REMOTE DIAGS F3
FLASH FILES F3
or to clear files from the flash
CLEAR ALL FILES F3
, only application files stored in the flash-based file
x
810 device is in
is
SYS MODE MENU 2
and the
SYS MODE MENU 2
). To stop the upload,
*
in
SYS MODE MENU 1