VeriFone Vx810 Reference Manual page 146

S M
YSTEM ESSAGES
Information Messages
SYS MODE KBD TEST
KEYCODE NN
SYS MODE PASSWORD
FILE GROUP NN
SYS MODE ENTRY
SYS MODE PASSWORD
NEW
AGAIN
PASSWORD CHANGED
SYS MODE UPLOAD
UPLOADING NOW
TRK1:
TRK2:
TRK3:
146
V X 810 R G
EFERENCE
This message is displayed when you initiate a local diagnostic test of the device
keyboard through
decimal ASCII keycode of each key pressed appears to the right of
example, pressing the
ASCII code, 31.
This message is displayed when you initiate the procedure for modifying existing
system mode passwords through
options displayed allow you to change the password of a file group (
system mode password (
This message is displayed when you select
modify the existing system mode password.
•
: Make the appropriate menu selections to enter the new password.
NEW
•
: Repeat the entry to confirm the new password.
AGAIN
•
PASSWORD CHANGED
In a back-to-back download, the sending device displays this message when you
initiate an upload from the receiving device. To stop the upload, press
either device.
When you invoke a local system mode diagnostic test of the magnetic stripe card
reader, status information appears for the data tracks (TRK1, TRK2, and TRK3)
on the card.
To perform this test, select
magnetic stripe card through the card reader.
or
NO DATA VALID DATA
in one of these two messages for each track. Actual data stored on the card is not
displayed.
An error condition generates one of the following error messages for each track
with an error:
•
NO DATA
•
NO START
•
NO END
•
LRC ERR
•
PARITY ERR
•
REVERSE END
Press to end the local diagnostic test of the card reader.
CANCEL
UIDE
in
KEYBOARD DIAG F1 SYS MODE MENU 3
key on the device keypad displays the corresponding
1
PASSWORDS F2
).
F3
: Displayed when the new password is accepted.
MAG CARD DIAG F2
: A successful test of the magnetic stripe card reader results
. When invoked, the
in
SYS MODE MENU 2
in
PASSWORDS F2 SYS MODE MENU 2
in and swipe a
SYS MODE MENU 3
. For
KEYCODE
. The menu
) or the
F2
to
on
CANCEL