Paper Separator Removal; Printhead Removal; Print Media Selection Lever Removal (06C/06F/071); Second Paper Tray Option Connector Removal - Lexmark OptraTM Service Manual

4026-0XX

Paper Separator Removal

1. Remove the paper feed input tray assembly.
2. Remove the lift plate assembly.
3. Remove the manual feed guide plate.
4. Remove the engine board.
5. Remove the controller board.
6. Remove the paper feed frame assembly.
7. Use a screwdriver to release either side of the separator
latches.
8. Remove the paper separator.

Printhead Removal

1. Unplug the power cord from the machine.
2. Remove the left, right, and front covers.
3. Disconnect CN5 and CN10 printhead cables from the engine
board.
4. Remove the four screws from the main frame.
5. Remove the 14 mm screw located in the center of the lower
frame.
6. Gently pry the printhead locator tabs from the left and right main
frame mounting slots and remove the printhead.

Print Media Selection Lever Removal (06C/06F/071)

1. Place the printer on it's back.
2. Remove the selection lever mounting screw.
3. Remove the print media selection lever.

Second Paper Tray Option Connector Removal

1. Unplug the power cord from the machine.
2. Remove the left, right, and front covers.
3. Disconnect the CN9 cable from the engine board.
4. Remove the two screws holding the option connector to the
main frame.
5. Remove the second paper tray option connector.
Repair Information 4-13