Service Error Codes - Lexmark OptraTM Service Manual

4026-0XX

Service Error Codes

When a service error occurs the printer stops printing and all
operator panel LEDs blink in a continuous pattern, indicating a
service error, until the printer is powered off.
Press and release the operator panel button to display the service
error code. Locate the blinking LEDs in the following table and take
the indicated action.
Blinking Operator Panel LED
Software Service Error Code
Fuser Failure Error
Mirror Motor Error
Laser Diode Failure
2-2
Action
Run the Printer Diagnostic Test to
diagnose between the ROM SIMM
and the controller board. If no other
error code displays after the test
completes, replace the controller
board.
Go to the "Cold Fuser Service
Check" on page
The Polygon Mirror Motor is not
rotating during printing. Replace the
engine board. If this does not correct
the problem, replace the printhead
assembly.
Replace the printhead assembly. If
this does not correct the problem,
replace the engine board.
2-18.