4026-0XX
Paper Tray Two selected in the application. Paper does not feed
from Tray Two but instead feeds from Tray One. Tray Two reset to
Tray One in printer utility.
FRU
1
Engine Board
Action
Be sure the voltage at CN9-8 on the engine
board measures approximately 0 V dc. If incor-
rect, turn the printer power off and measure the
resistance between ground and CN9-8. Be sure
the resistance measures 0 ohms. If incorrect, be
sure the tray two cable measures continuity. If
incorrect, replace the cable. If correct, replace
the following FRUs one at a time in the order
shown:
Engine Board
Tray Two Sensor Board
Diagnostic Information 2-31