Resetting - Mercedes-Benz M-Class Operator's Manual

Using the SmartKey
i
The SmartKey must be close to the
driver's door handle.
Point the tip of the SmartKey at the driver's
X
door handle.
Press and hold the & button until the
X
side windows and the sliding sunroof or the
panorama roof with power tilt/sliding
panel are fully closed.
Make sure that all the side windows and the
X
sliding sunroof or panorama roof with
power tilt/sliding panel are closed.
On vehicles with a panorama roof with power
tilt/sliding panel:
Press and hold the & button again until
X
the roller sunblinds of the panorama roof
with power tilt/sliding panel close.
To interrupt convenience closing:
X
release the & button.
Using KEYLESS-GO
The KEYLESS-GO key must be outside the
vehicle. All the doors must be closed.
Touch recessed sensor surface : on the
X
door handle until the side windows and the
sliding sunroof or the panorama roof with
power tilt/sliding panel are fully closed.
i
Make sure you only touch recessed
sensor surface :.
Make sure that all the side windows and the
X
sliding sunroof or panorama roof with
power tilt/sliding panel are closed.
On vehicles with a panorama roof with power
tilt/sliding panel:
Touch recessed sensor surface : on the
X
door handle again until the roller sunblinds
of the panorama roof with power tilt/
sliding panel close.
To interrupt convenience closing:
X
release recessed sensor surface : on the
door handle.
Resetting the side windows
If a side window can no longer be closed fully,
you must reset it.
Close all the doors.
X
Turn the SmartKey to position 1 or 2 in the
X
ignition lock.
Pull the corresponding switch on the door
X
control panel until the side window is
completely closed (
Hold the switch for an additional second.
X
If the side window opens again slightly:
Immediately pull the corresponding switch
X
on the door control panel until the side
window is completely closed (
Hold the switch for an additional second.
X
If the corresponding side window remains
X
closed after the button has been released,
the side window has been reset correctly.
If this is not the case, repeat the steps
above again.
Problems with the side windows
Problem: a side window cannot be closed
because it is blocked by objects, e.g.
leaves in the window guide.
Remove the objects.
X
Close the side window.
X
Problem: a side window cannot be closed
and you cannot see the cause.
I n f o r ma t i o n P r o v i d e d b y :
Side windows
page 85).
Y
page 85).
Y
Z
87