Floormat - Mercedes-Benz M-Class Operator's Manual

Features
308
out). Press the remote control button again
before it stops transmitting.
align the antenna cable of the garage door
R
opener unit. This can improve signal
reception/transmission.
Opening/closing the garage door
Once programmed, the integrated garage
door opener will assume the function of the
garage door system's remote control. Please
also read the operating instructions for the
garage door system.
Turn the SmartKey to position 2 in the
X
ignition lock.
Press transmitter button ;, = or ? in the
X
overhead control panel that you have
programmed to operate the garage door.
Garage door system with a fixed code:
indicator lamp : lights up green.
Garage door system with a rolling code:
indicator lamp : flashes green.
i
The transmitter will transmit a signal for
as long as the transmitter button is being
pressed. After a maximum of ten seconds,
transmission is terminated and indicator
lamp : flashes yellow. Press the
transmitter button again, if necessary.
Clearing the memory of the integrated
garage door opener on the rear-view
mirror
Turn the SmartKey to position 2 in the
X
ignition lock.
Press transmitter buttons ; and ?.
X
The indicator lamp lights up yellow.
Press and hold transmitter buttons ;
X
and ? until the indicator lamp turns green.
i
Make sure that you clear the memory of
the integrated garage door opener before
selling the vehicle.
Compass
Calling up the compass
Information on operating the compass can be
found in the separate COMAND operating
instructions.
Floormats
G
WARNING
Whenever you are using a floormat, make sure
there is enough clearance and that the
floormat is securely fastened.
The floormat should always be securely
fastened using the fastening equipment.
Before driving off, check that the floormat is
securely in place and adjust it if necessary. A
loose floormat could slip and hinder proper
functioning of the pedals.
Do not place several floormats on top of each
other as this may impair pedal movement.
Floormat on the driver's side (example)
Driver's seat/front-passenger seat:
X
slide the respective seat back.
Rear seats: slide the respective seat
X
forwards.
To install: place the floormat in the
X
footwell.
Press studs : onto retainers ;.
X
To remove: pull the floormat off
X
retainers ;.
Remove the floormat.
X
I n f o r ma t i o n P r o v i d e d b y :