Mercedes-Benz M-Class Operator's Manual page 309

Turn the SmartKey to position 2 in the
X
ignition lock.
Press the programming button of the door
X
or gate drive (see the door or gate drive
operating instructions, e.g. under
"Programming of additional remote
controls").
i
You now normally have 30 seconds to
initiate the next step.
Press the previously programmed
X
transmitter button of the HomeLink
integrated garage door opener repeatedly
in succession until the door opens.
The rolling code synchronization is then
complete.
Notes on programming the remote
control
Canadian radio frequency laws require a
"break" (or interruption) of the transmission
signals after broadcasting for a few seconds.
These signals may not therefore last long
enough for the integrated garage door opener
to recognize the signal during programming.
Comparable with Canadian law, some U.S.
garage door openers also have a built-in
"interruption".
If you live in Canada or have difficulties
programming the garage door opener
(regardless of where you live) when using the
programming steps (see above), proceed as
follows:
Press and hold one of transmitter
X
buttons ; to ? of the integrated garage
door opener.
Indicator lamp : starts to flash yellow
after a short period.
Release the transmitter button.
X
Press transmitter button B of the garage
X
door remote control and hold for two
seconds, then release for two seconds,
then press again and hold for two seconds.
Repeat this sequence on transmitter
X
button B of the garage door remote
control until indicator lamp : is green.
Repeat the process if indicator lamp :
turns red.
Continue with the other programming
X
steps (see above).
Problems when programming
If you are experiencing problems
programming the integrated garage door
®
opener on the rear-view mirror, take note of
the following instructions:
check the transmission frequency of
R
garage door remote control A (usually
found on the reverse side of the remote
control).
The integrated garage door opener is
compatible with devices that can be
operated with units in a frequency range of
280 to 390 MHz.
change the batteries in garage door remote
R
control A. This increases the probability
that garage door remote control A will
send a strong and precise signal to the
integrated garage door opener on the rear-
view mirror.
when programming, hold garage door
R
remote control A at different distances
and angles from the transmitter button that
you are programming. Try different angles
at a distance between 2 and 12 inches (5
to 30 cm) or the same angle at varying
distances.
if another remote control for the same
R
garage door drive is available, repeat the
same programming steps with this remote
control. Before you perform the steps of the
operation, make sure that there are new
batteries in the garage door remote
control.
note that some remote controls only
R
transmit for a limited amount of time (the
indicator lamp on the remote control goes
I n f o r ma t i o n P r o v i d e d b y :
Features
307
Z