Yamaha FX10X 2008 Service Manual page 53

Table of Contents

Oil replacement

Oil replacement steps:

• Remove the right lower cover.

Refer to "COVERS" in CHAPTER 3.

• Place the drive chain cover under the drain

• Remove the oil drain bolt (along with the gas-

ket) 1 and drain the oil.

Be sure to remove any oil from the heat protec-

• Install the new gasket and oil drain bolt 1.

Oil drain bolt:

16 Nm (1.6 m · kg, 11 ft · lb)

Recommended oil:

Gear oil "GL-3" 75W or 80W

Oil capacity:

0.20 L (0.18 Imp qt, 0.21 US qt)

Chain slack adjustment

• Drive chain slack

Adjustment steps:

• Loosen the locknut 1.

• Turn the adjusting bolt 2 clockwise until it is fin-

ger tight, and then loosen it 1/4 turn.

• Hold the adjusting bolt 2 in place while tighten-

ing the chain adjusting locknut 1.

Drive chain adjusting locknut:

25 Nm (2.5 m · kg, 18 ft · lb)

Troubleshooting