Table of Contents
Advertisement
F
W
D
b
d
1
a
b
3
5
6
a
c
1
2
3-14
STEERING
• Loosen the steering shaft locknuts 5.
• Adjust the steering shaft 6 by turning so that
the pivot arm point right under.
Turning the steering
shaft in direction a
Turning the steering
shaft in direction b
• Tighten the steering shaft locknuts 5.
Steering shaft locknut:
25 Nm (2.5 m · kg, 18 ft · lb)
®
LOCTITE
• Adjust each angle of right and left skis by turn-
ing the tie rod respectively.
• Measure the ski toe-out.
Refer to "STEERING SYSTEM" in CHAPTER 2.
7. Install:
For FX10RT/FX10RTR/FX10RTRA
• Steering joint 1
• Steering joint holders 2
NOTE:
• Install the steering joint with the shallow cutout a
facing forward.
• Align the centerline of the steering joint with the
centerline of the steering column 3 as shown in
the illustration.
• The steering joint holders should be installed
with punch marks b facing forward.
CAUTION:
First, tighten the bolts on the front side of the
steering joint holder, and then on the rear side.
CHAS
Turning the ski in
direction c
Turning the ski in
direction d
Advertisement
Table of Contents
Troubleshooting
