Table of Contents
Advertisement
1 Fasten the wire harness to the
frame rear cross member with
the plastic band. Face the end of
the plastic band downward.
2 Positive battery lead
3 Coolant reservoir hose
4 To the main switch
5 To the brake master cylinder
6 Brake hose
7 To the parking brake lever
8 Parking brake cable
9 To the left handlebar switch
0 Pass the plastic band through
the holes in the rubber cover,
and then fasten the cover with
the band, making sure that the
band is not fastened over the
projections at the top of the
cover.
A Slide the rubber coupler over the
grip/thumb warmer adjustment
switch coupler, left grip warmer
coupler, brake light switch cou-
pler, and headlight beam switch
coupler.
B To the air filter case
C Fasten the wire harness to the
headlight stay with the plastic
band.
D Oil tank breather hose
E Main fuse
F Starter relay
G Starter motor lead
H Fasten the starter motor lead to
the oil tank inlet hose with the
plastic band, making sure not to
pinch the hose.
I Fasten the stator coil lead to the
front frame with the plastic band,
making sure to route it to the
inside of the frame.
J To the rectifier/regulator
K To the engine
L Fasten the positive battery lead
to the oil tank breather pipe with
the plastic band.
M To the AC magneto
N Pass the negative battery lead
between the parking brake cable
and the frame.
O Route the starter motor lead (to
the starter motor) to the rear of
the engine.
P Thermostat outlet hose
Q Pass the parking brake cable
through the holder, making sure
that the holder is positioned to
the front of the bolt.
CABLE ROUTING
9-36
SPEC
Advertisement
Table of Contents
Troubleshooting
