Power Train; Sheave Offset Adjustment - Yamaha FX10X 2008 Service Manual

Table of Contents

POWER TRAIN

SHEAVE OFFSET ADJUSTMENT

• Left side cover

• Drive guard

Refer to "COVERS" in CHAPTER 3.

• Drive V-belt

• Sheave offset a

Use a straightedge that is approximately

470 mm (18.5 in) long, 20 mm (0.79 in) wide,

and 4 mm (0.16 in) thick.

Out of specification → Adjust.

Sheave offset:

13.5 ~ 16.5 mm (0.53 ~ 0.65 in)

Push the secondary sheave inward towards the

frame, and then measure the sheave offset.

• Sheave offset

Adjustment steps:

• Apply the brake to lock the secondary sheave.

• Remove the secondary sheave bolt 1, washer

2, shim(s) (left), and secondary sheave 3.

• Install the appropriate shim(s) (right) 4 from the

following table so that the sheave offset is within

specification.

1.0 mm (0.04 in)