Yamaha FX10X 2008 Service Manual page 395

P Rectifier/regulator lead
Q Rectifier/regulator
R Route the coolant reservoir
breather hose above the coolant
reservoir check window.
S ECU (engine control unit)
T Fasten the coolant reservoir
breather hose to the front frame
with the plastic band, making
sure not to pinch the hose.
U Intake air temperature sensor
V Route the wire harness above
the intake air temperature sen-
sor.
W Fasten the wire harness, at the
portion just before the leads split,
to the headlight stay with the
plastic band.
X To the headlight (left)
Y Slide the rubber coupler over the
engine stop switch coupler, throt-
tle switch couplers, right grip
warmer coupler, and thumb
warmer coupler.
Z Pass the plastic band through
the holes in the rubber cover,
and then fasten the cover with
the band, making sure that the
band is not fastened over the
projections at the top of the
cover.
[ To the headlight (right)
\ Speedometer unit sub-lead cou-
pler
] To the right handlebar switch
_ To the speedometer unit
a Route the fuel injection system
sub-wire harness (to the throttle
body) to the right of the radiator
outlet hose.
b 10 mm (0.39 in)
c Radiator fan motor lead
d To the wire harness
e Ignition coils
f Rearward
CABLE ROUTING
9-34
SPEC