Table of Contents
Advertisement
THROTTLE BODY SYNCHRONIZATION
THROTTLE CABLE FREE PLAY ADJUSTMENT
1
1
a
Adjustment steps:
• With throttle body #1 as standard, adjust throttle
body #1 and #2 using the synchronizing screws
1.
Carburetor angle driver 2:
90890-03173
NOTE:
After each step, rev the engine two or three times,
each time for less than a second, and check the
synchronization again.
Vacuum pressure at engine idling
speed:
25.37 ~ 28.03 kPa
(0.25 ~ 0.28 kg/cm
NOTE:
The difference in vacuum pressure between two
throttle bodies should not exceed 1.3 kPa (0.01
2
kg/cm
, 0.18 psi).
7. Stop the engine and remove the measuring
equipment.
8. Adjust:
• Throttle cable free play
Refer to "THROTTLE CABLE FREE PLAY
ADJUSTMENT".
THROTTLE CABLE FREE PLAY
ADJUSTMENT
NOTE:
Adjust the throttle cable free play while the cable is
in the cable guide.
1. Measure:
• Throttle cable free play a
Out of specification → Adjust.
Throttle cable free play:
3.0 ~ 4.0 mm (0.12 ~ 0.16 in)
2-14
INSP
ADJ
2
, 3.61~ 3.99 psi)
Advertisement
Table of Contents
Troubleshooting
