Yamaha FX10X 2008 Service Manual page 391

R Face the ends of each hose
clamp toward the fuel tank.
S Fuel sender coupler
T Fasten the tail/brake light lead
(wire harness side) to the frame
rear cross member with the plas-
tic band.
U Tail/brake light coupler
V Fuel pump lead
W Fasten the tail/brake light lead
with the holders, making sure to
push the lead against the fuel
tank.
X Fuel hose connector holder
Y Fuel hose
Z Fasten the fuel hose and fuel
pump lead with the plastic band.
Align the plastic band with the
positioning tape on the fuel pump
lead and install it with its buckle
facing toward the fuel tank.
[ Be sure to install the fuel tank
breather hose with its long end
facing to the right.
\ Face the ends of the hose clamp
rearward.
] ISC (idling speed control) unit
_ 20 ~ ~
40 mm (0.79 1.57 in)
a Speed sensor coupler
b Radiator fan motor coupler
c Fuel injection system sub-wire
harness coupler
d Intake air pressure sensor 1 (cyl-
inders #1, #2, and #3)
e Intake air pressure sensor 2 (cyl-
inder #1)
f Fasten the wire harness, oil pres-
sure switch sub-lead, and crank-
shaft position sensor lead to the
frame rear cross member with
the plastic band.
g Cylinder head breather hose.
h Fasten the coolant reservoir
hose with the holder.
i Intake air temperature sensor
j Coolant reservoir hose
k Fasten the wire harness, at the
portion just before the leads split,
to the front frame with the plastic
band.
l To the coolant reservoir
m Install the ground lead terminal to
the left side of the front frame,
making sure to face the crimped
portion of the terminal inward.
CABLE ROUTING
9-30
SPEC