Installing The Handlebar - Yamaha FZS600'98 Service Manual

EB704701

INSTALLING THE HANDLEBAR

1. Stand the motorcycle on a level surface.
2. Install:
b
3. Install:
4. Install:
5. Install:
7-51
HANDLEBAR
Securely support the motorcycle so that
there is no danger of it falling over.
S handlebar 1
S upper handlebar holders 2
23 Nm (2.3 mSkg)
CAUTION:
S First, tighten the bolts on the front side
a of the handlebar holder, then on the
rear side.
S turn the handlebar all the way to the left
and right. If there is any contact with the
fuel tank, adjust the handlebar posi-
tion.
NOTE:
S The upper handlebar holders should be
installed with the arrows facing forward.
S Align the match marks b on the handlebar
with the upper surface of the lower handle-
bar holders.
S clutch lever holder
S handlebar grip 1
S left grip end 2
NOTE:
There should be 1.0 mm of clearance a be-
tween the handlebar grip and the left grip
end.
S left handlebar switch 1
NOTE:
Align the projection a on the left handlebar
switch with the hole b in the handlebar.
S master cylinder bracket 1
NOTE:
Align the mating surfaces of the master cyl-
inder bracket with the punch mark (right han-
dlebar switch side) a on the handlebar.
CHAS