Replacing The Rear Brake Pads - Yamaha FZS600'98 Service Manual

FRONT AND REAR BRAKES
EB702113

REPLACING THE REAR BRAKE PADS

NOTE:
When replacing the brake pads, it is not nec-
essary to disconnect the brake hose or dis-
assemble the brake caliper.
1. Remove:
S brake caliper 1
2. Remove:
S brake pad pins 1
3. Remove:
S brake pads 2
(along with the brake pad shims)
S brake pad spring
4. Measure:
S brake pad wear limit a
Out of specification ! Replace the brake
pads as a set.
5. Install
S brake pad shims
(onto the brake pads)
S brake pads
S brake pad spring
NOTE:
Always install new brake pads, brake pad
shims, and a brake pad spring as a set.
a. Connect a clear plastic hose 1 tightly to
b. Loosen the bleed screw and push the
c. Tighten the bleed screw.
d. Install a new brake pad shim 3 onto each
e. Install new brake pads and a new brake
7-18
CHAS
Brake pad wear limit
0.5 mm
the bleed screw 2 . Put the other end of
the hose into an open container.
brake caliper pistons into the brake cali-
per with your finger.
6 Nm (6 mSkg)
new brake pad 4 .
pad spring.