Lock Washers/Plates And Cotter Pins - Yamaha FZS600'98 Service Manual

OR
IMPORTANT INFORMATION
EB102030
LOCK WASHERS/PLATES AND COTTER
PINS
1. After removal, replace all lock washers/
plates 1 and cotter pins. After the bolt or nut
has been tightened to specification, bend
the lock tabs along a flat of the bolt or nut.
EB102040
BEARINGS AND OIL SEALS
1. Install bearings and oil seals so that the
manufacturer's marks or numbers are vis-
ible. When installing oil seals, apply a light
coat of lithium soap base grease onto the oil
seal lips. Oil bearings liberally when instal-
ling, if appropriate.
Oil seal
1
CAUTION:
Do not spin the bearing with compressed
air because this will damage the bearing
surfaces.
Bearing
1
EB102050
CIRCLIPS
1. Before reassembly, check all circlips careful-
ly and replace damaged or distorted circlips.
Always replace piston pin clips after one
use. When installing a circlips 1 , make sure
that the sharp-edged corner 2 , is positioned
opposite the thrust 3 that the circlip re-
ceives.
Shaft
4
1-3
GEN
INFO