Transmitter Chassis (301), Scanner Assembly (340), Led Array Assembly (333), Verification Stamp Assembly - Panasonic DX-2000 Service Manual

2.6. Transmitter Chassis (301), Scanner Assembly (340),
LED Array Assembly (333), Verification Stamp Assembly
(6)
(5)
(4)
(5)
(9)
(2)
Mirror 2
(5)
(2)
(2)
(7)
(8)
(2)
(1)
(1)
Mirror 1
(1) Remove the Front Cover (105), Rear Cover (108) (Refer
to 2.3.) and the Control Panel Unit (Refer to 2.5.).
(2) Remove all the harnesses from the clamps.
(3) Disconnect Connector CN8 on the FCB PC Board.
(4) 1 Screw and remove the Front Bracket 2 (136).
(5) 4 Screws (19).
(6) Remove the Transmitter Chassis (301) Assembly.
(7) Disconnect Connector CN30 on the CCD PC Board.
(8) 2 Screws (19).
(9) Remove the Scanner Assembly (340).
Note: When reinstalling the CCD Harness,
1. Separate the CCD Harness (545) from the other
harnesses.
2. Place the other harnesses into the Harness Protector Film
(556).
Cleaning Mirror 1 (337), Mirror 2 (338)
Clean the Mirror 1 (337) and Mirror 2 (338) with a soft cloth,
soaked with isoproyl alcohol.
32