Table of Contents
Advertisement
(10)
(11)
(14)
(15)
(13)
(12)
(17)
(16)
321
(10) Disconnect the Ribbon Cable from CN50 on the FCB PC
Board in the machine.
(11) Remove the Internet Module.
(12) Remove 3 Screws.
(13) Remove the Rear Cover.
(14) Insert the PCB Spacer into the hole on the PDL PC Board.
(15) Connect the PDL PC Board to the CN55 on the FCB PC
Board.
(16) Secure the PDL PC Board by inserting the PCB Spacer into
the hole on the FCB PC Board.
(17) Remove 1 Screw on the FCB PC Board and connect the
GND Cable with the screw.
Advertisement
Table of Contents
Troubleshooting
