A. Ar-D28 - Olivetti d-Copia 3501 Service Manual

4. Unpacking and installation of the
desk unit

A. AR-D28

<Before installation>
• Start installation after checking that the DATA and COMMUNI-
CATION indicators on the operation panel are neither lit nor
blinking.
<Parts included>
Front mounting
plates: 2 pcs.
Left adjuster: 1 pc.
Left paper guides: 2 pcs.
1) Turn off the main switch of the main unit of the printer.
Turn the main switch located on the front side of the printer to
the "OFF" position.
Then remove the power plug from the outlet.
2) Attach the adjusters and adjust them.
<1> Insert the left adjusters to the stand/paper drawer.
<2> Turn the each adjusters to lower them until they touch the
floor.
2
2
1
Be sure to attach the left adjuster to prevent overturning.
∗
Caution: The lower tray cannot be pulled out unless the adjuster
is lowered to the specified position.
6-4
Rear mounting Screws (M4x6):
4 pcs.
plates: 2 pcs.
Right paper guides: 2 pcs.
"OFF"
2
2
Service Manual
3) Put the main unit of the printer on the stand/paper drawer.
<1> Pull out the paper tray of the main unit until it stops and then
remove it by lifting both ends of the tray.
<2> Hold the main unit of the printer at the positions shown in the
illustration and put the main unit on the stand/paper drawer
so that the front side and the left side of the main unit are
aligned to those of the stand/paper drawer.
Caution: For installation of the main unit, it must be held by two
persons and installed without haste.
4) Connect the main unit to the stand/paper drawer.
<1> Attach the rear mounting plates using a supplied screw for
each.
Rear mounting plate
Desk frame
Caution: Insert the rear mounting plates under the desk frame.
<2> Pull out the upper paper tray of the stand/paper drawer until it
stops and attach the front mounting plates using a supplied
screw for each.
Then, remove the lock of the paper tray and close the tray.
Front mounting
Screw
plate
Front side
Rear side
Rear mounting plate
Screw
Screw
Rear
mounting plate
Front
mounting plate
Screw
Y105220-6