D-Copia 3501/3501Mf - 4501/4501Mf - Olivetti d-Copia 3501 Service Manual

I I nstalling procedure flowchart - d-Copia 3501/3501MF - 4501/4501MF
There are many combinations between this machine and option
units. For installing option units, observe the following procedures
for efficiency.
To install the devices effciently, follow the procedure below.
Some peripheral devices may have been installed as standard
devices depending on the main unit model.
Part of descriptions and illustrations may be different.
Scanner/document feeder device
Finishing device
Duplex device
Start of installation
Main unit, paper feeding
device, and power supply
unit.
AR-MU2
AR-D27
AR-D28
Main unit
Yes
Duplex/bypass
device installed?
No
Yes
Finishing device
installed?
No
∗ For installation of an option unit, refer to the Service Manual of the option unit.
6-2
Main unit
Paper feeding device
B y i n s t a l l i n g o p i o n A R-M U 2, t h i s p r o d u c t c a n b e u s e d e x c l u s i v e l y a s a d e s k t o p r i n t e r.
Install duplex/pypass device.
AR-DU3
AR-DU4
Install finishing device.
AR-MS1
AR-FN6
AR-FN7
AR-PN1XX
Service Manual
Duplex/bypass device
Finishing device
.
Controller board,
facsimile unit or other
electric devices
installed?
No
[Electrical setting/adjustment]
1) Installation of driver software, setting,
and operation check
Main unit/AR-EF3/AR-FX12/AR-PK6/MX-NSX1
2) Paper guide position adjustment/off center adjustment
AR-MU2/AR-D27/AR-D28/
AR-DU3/AR-DU4
End
When installing a paper feeding device or a duplex/bypass device, be sure to reattach
the rear cabinet, the AC inlet cover, and the harness cover of the main unit at the end
of installation as needed.
When installing a controller board, a facsimile unit, and other electric devices, be sure to install them
at a time.
Only off center adjustment is needed for AR-DU3.
Finishing device
Main unit
Paper feeding device
Install controller board,
facsimile unit or other electric
devices.
Yes
AR-MM9
AR-PK6
MX-NSX1
Extended memory
Y105220-6