Canon NP6251 Service Manual page 171

Reference:
To form a loop, wind the wiring wire around a hex key once; then, turn the hex key
three to four times, and twist the wire.
5) Cut the twisted charging wire (excess) with a nipper.
6) Hook the loop on the stud A shown in Figure 4-331.
7) After stringing it 31 runs, route it through section B, and give it a half turn; then, lead
it between the washer and the motor unit, and wind it around the mounting screw
once (clockwise), and fix it in place with a mounting screw.
8) Cut the excess charging wire with a nipper.
9) Tighten the screw loosened in step 3).
Turn the screw until the tension of the grid wire is even.
Pay attention to avoid deformation and slack; if necessary, try to tighten the mounting
screw on the left/right shielding plate at the front earlier.
10) Tighten the mounting screws loosened in steps 1) and 2).
11) Wipe the grid wire with lint-free paper moistened with alcohol.
Caution:
Check to make sure that the grid wire is not bent or twisted.
Check to make sure that the wire is strung at equal intervals (i.e., it is in the
groove of the block).
COPYRIGHT © 1997 CANON INC.
Download service manual and resetter printer at http://printer1.blogspot.com
Stud A
Figure 4-331
CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 4 IMAGE FORMATION SYSTEM
Screw
B
4-57