Canon NP6251 Service Manual page 168

CHAPTER 4 IMAGE FORMATION SYSTEM
2) Remove the wire cleaner.
Caution:
For other charging assemblies, remove the two lids.
3) Free a length (about 5 cm) of wire from the charging reel, and form a loop at one end
(2 mm dia.).
Reference:
When forming a loop, you may wind the charging wire around a hex key once; then,
turn the key three to four times, and twist the wire.
4) Cut the end (excess) of the twisted wire with a nipper.
5) Hook the loop on the stud.
Stud
6) Hook the charging wire on the charging wire positioner at the rear; then, hook the
wire on the charging wire tension spring as shown in Figure 4-326, and twist it.
4-54
COPYRIGHT © 1997 CANON INC.
Download service manual and resetter printer at http://printer1.blogspot.com
Reel
(front)
Charging wire
Figure 4-325
Figure 4-326
CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
Charging corona electrode
(rear)