Sony SAL1680Z Service Manual page 28

HELP18
Anti-diffusion agent (A-20): J-6082-611-A
Adhesive bond (B-40):
Grease (G-35):
Grease (G-55):
Grease (G-115):
Grease (G-116):
Grease (G-117):
1. Apply the anti-diffusion agent (A-20) and following grease (G-B) to the indicated portion of MF operation ring.
Grease (G-B) = (G-116 : G-117 = 1 : 2)(Mix grease at the following rates before using the grease, and mix grease enough.)
2. Apply the anti-diffusion agent (A-20), grease (G-35) and following grease (G-A) to the indicated portion of torque ring holder.
Grease (G-A) = (G-115 : G-117 = 1 : 2)(Mix grease at the following rates before using the grease, and mix grease enough.)
3. Assemble the torque ring holder into the MF operation ring in the direction shown in the figure until it clicks.
4. Apply small amount of the adhesive bond (B-40) to the screw hole of pinch lever (Wipe seeping out bond off) and install the pinch
lever to the MF operationring by the pinch lever shaft. (two locations)
5. Apply small amount of the adhesive bond (B-40) to the screw hole of pinch lever B (Wipe seeping out bond off) and install the pinch
lever B to the MF operation ring by the pinch lever shaft. (One location)
6. Affix the friction sheet A to the inner side of focus ring B.
7. Apply the anti-diffusion agent (A-20), grease (G-55) and following grease (G-A) to the indicated portion of torque ring.
Grease (G-A) = (G-115 : G-117 = 1 : 2)(Mix grease at the following rates before using the grease, and mix grease enough.)
Note:
Wipe out the extra grease (G-55) on the area other than the indicated portion.
8. Assemble the MF operation ring, focus ring B and torque ring (setting the spring) in the orders shown in the figure.
Pinch Lever Shaft
Pinch Lever B
(Apply small amount
of the adhesive bond
(B-40) to the screw hole)
(Do not seep out)
MF Operation Ring
Torque Ring Holder
Focus Ring B
Friction Sheet A
Spring
Torque Ring
SAL1680Z (Vario-Sonnar DT 3.5-4.5/16-80 ZA) (Vario-Sonnar T
J-6082-614-A
J-6082-621-A
J-6082-623-A
J-6082-627-A
J-6082-628-A
J-6082-660-A
Pinch Lever Shaft
Pinch Lever B
(Apply small amount
of the adhesive bond
(B-40) to the screw hole)
(Do not seep out)
Apply the anti-diffusion
agent (A-20)
(All circumference)
Apply the grease (G-A)
(All circumference)
Apply the grease
(G-A)
(Three locations)
DT 16-80mm F3.5-4.5 ZA)
*
Apply the grease
(G-B)
(All circumference)
Apply the grease
(G-35)
(All circumference)
Apply the anti-diffusion
agent (A-20)
(All circumference)
Friction
Sheet A
Apply the anti-diffusion
agent (A-20)
(All circumference)
Apply the grease (G-A)
(All circumference)
Apply the grease (G-55)
(All circumference)
HELP