2. Adjustment Procedure
1) Set the focus ring to the infinity end by rotating the focus ring.
2) By moving the focus scale plate by finger align the ∞ mark on the focus scale plate with the projection of outer barrel.
3) Apply the adhesive bond (B-10) to the hole of focus scale plate in the hole of outer barrel as shown in the figure.
Focus Rubber Ring
Outer Barrel Assy
Apply the adhesive bond (B-10)
Focus Scale Plate
Projection
Infinity Mark
Fig.4-6-2
SAL1680Z (Vario-Sonnar DT 3.5-4.5/16-80 ZA) (Vario-Sonnar T
DT 16-80mm F3.5-4.5 ZA)
*
4-28