Sony SAL1680Z Service Manual page 29

HELP19
Grease (G-15): J-6082-619-A
1. Apply the grease (G-15) to the gear of focus ring and the indicated portion.
2. Rotate clockwise the focus lens holder as far as it goes and set the zoom to the wide end.
3. Place the long side of focus stopper to the gear side as shown in the figure and install it in the groove of focus ring.
4. Aligning the end of gear of focus ring with the hole of outer barrel as shown in figure, assemble the focus ring into the outer barrel
assembly.
5. Turn a little clockwise the focus ring so that the screw holes of focus stopper can be seen in the two holes of outer barrel assembly.
6. Tighten two screws.
Focus Stopper
Apply the grease (G-15)
(Gear)
Focus Lens Holder
SAL1680Z (Vario-Sonnar DT 3.5-4.5/16-80 ZA) (Vario-Sonnar T
Focus Ring
Long
Short
Screws
Apply the grease
(G-15)
(All circumferences)
Outer Barrel Assy
DT 16-80mm F3.5-4.5 ZA)
*
HELP