4-11. FOCUS BRUSH POSITION CHECK/ADJUSTMENT AND PATTERN CHECK
4-11-1. Focus Brush Position Adjustment (Search Focus Adjustment Point)
Equipment
• Personal Computer
• Finished Inspection JIG (AC100 V only)
• Lens Adjustment Program (ActuatorChecker)
• Adhesive bond (B-10)
1. Preparations
1) Remove the zoom rubber ring and zoom hold ring from the lens unit.
Note:
After removing the zoom hold ring, do not move the zoom barrel in the arrow direction. If moved, the zoom brush will be
deformed.
Screw
Screw
2) Connected to equipment with checking lens. (Refer to Section 4-1-3.)
3) Start up of "ActuatorChecker.exe".
[Set up]
4) Click
, and perform the initial setting. (Refer to Section 4-1-4.)
SAL1680Z (Vario-Sonnar DT 3.5-4.5/16-80 ZA) (Vario-Sonnar T
Zoom Rubber Ring
Zoom Hold Ring
Zoom Barrel
Fig.4-11-1
Screw
DT 16-80mm F3.5-4.5 ZA)
*
4-42