Table of Contents
Advertisement
Error Conditions
The following table shows messages which indicate an error
condition, and the suggested corrective action.
No dial tone
Busy error
DCD low
DSR low
PPP up fail
Time out
No carrier
No answer
The modem could not obtain a dial tone.
Check your connections on the phone line
and the modem.
The number dialed was busy. Check that
the number is correct. If it is, try dialing
later. If this occurs regularly, check with
your ISP.
The connection was lost. This could
indicate a bad line or poor connection.
Normally, if a connection is lost, it will
automatically be re-established.
The ISP rejected the attempt at connection.
Check that your username and password is
correct. If it is, check with your ISP to see
why the connection is being rejected.
No response. Check that the modem is ON
and properly connected to the Internet
Gateway.
There was no response from the phone
number dialed. Check that the phone
number is correct, and the modem is
working. If both of these are OK, check
with your ISP.
Status and Monitoring
Advertisement
Table of Contents
