Konica Minolta IC-304 Plus Service Manual page 116

100
3. Push the memory module gently downward until the locking clips click into
position. See Figure 7 on page 99.
Locking clip seat.
Figure 8: Memory module and locking clip seat
Note:
When replacing FusionIN board memory modules, verify that you are using
the same memory size and type. See Spare Parts List on page 91.
The FusionIN board memory modules are exclusive to the IC-304 print
controller and are not interchangeable with any other memory modules.
Preparing the FusionIN Board
1. Touch the sides of the new board's antistatic packet to an unpainted area of the
server chassis, and then remove the new board from the packet.
WARNING: Avoid touching the components and gold-plated connectors
on the adapter.
2. Place the board, component-side up, on a flat, antistatic surface.
Installing the FusionIN Board
1. Carefully grasp the board by its top edge or upper corners, and align it with the
expansion slot (PCIX-133) on the system board.
2. Press the board firmly into the expansion slot. Verify that the board fits securely
in the expansion slot and is locked in position.
Attention:
When you replace a board in the server, ensure that it is
completely and correctly seated in the system board expansion slot before
applying power. Incorrect seating might cause damage to the system
board or any other board.
3. If you have other options to remove or replace, do so now.
4. Insert the hexagonal screw that holds the board at the rear of the server and
tighten it.
5. Return the side cover. See Returning the Side Cover on page 94.
6. Reconnect all external cables and power cords, and turn on the server.
Chapter 4—Hardware and Maintenance Repairs